Agricultural abandoned lands as emission sources of dust containing metals and pesticides in the Sonora-Arizona Desert.

This investigation examines the transport of metal- and pesticide-polluted dust emitted by one of the most relevant agricultural areas of Northwestern Mexico. In the contaminated area, an excessive water extraction of the aquifer and seawater intrusion caused the abandonment of fields, which are pollutant-loaded dust emitters. We used air mass forward trajectories (HYSPLIT) model to obtain particle trajectories in the wind and the use of banned pesticides as geochemical tracers for dust transported by wind. Fifty dust samples from 10 agriculture fields and 26 roof dust of a city close to the agricultural area were analyzed for their contents of zirconium, lead, arsenic, zinc, copper, iron, manganese, vanadium, and titanium, by portable X-ray fluorescence. Nine pesticides were analyzed in the roof dust and agricultural soil samples by gas chromatography. Results show that the distribution of metals was significantly different between active and abandoned fields. Arsenic-lead-copper was mainly concentrated in abandoned fields, while zinc-iron-manganese-titanium was dominant in active fields. Two potential sources of metal contamination were found by principal component analysis (PCA): (I) a mixture of traffic and agricultural sources and (II) a group related to agricultural activities. The occurrence of banned pesticides in dust deposited on roofs collected at nearby cities confirms the atmospheric transport from the agricultural area. The HYSPLIT results indicated that the dust emitted from agricultural fields can reach up to the neighboring states of Sonora, Mexico, and the USA. The impacts that these emissions can have on human health should be studied in future research.

Characterization and Polydispersity of Volcanic Ash Nanoparticles in Synthetic Lung Fluid.

The inhalation of natural nanoparticles (NPs) emitted from volcanic activity may be a risk to human health. However, the literature rarely reports the fate and response of NPs once in contact with lung fluids. In this work, we studied the particle size distribution of ashfall from Popocatépetl volcano, Mexico. The collected ashes (n = 5) were analyzed with scanning electron microscopy (SEM) to obtain the elemental composition and morphology, and to determine the size of the ash particles using ParticleMetric software (PMS). The PMS reported most of the ash to have submicrometric size (<1 µm) and an average equivalent circle of 2.72 µm. Moreover, to our knowledge, this study investigated for the first time the behavior of ash NPs at different times (0 to 24 h) while in contact with in vitro lung fluid, Gamble Solution (GS) and Artificial Lysosomal Fluid (ALF) using dynamic light scattering (DLS). We found a large variability in the hydrodynamic diameter, with values less than 1 nm and greater than 5 µm. Furthermore, aggregation and disaggregation processes were recognized in GS and ALF, respectively. The results of this study increase the knowledge of the interaction between NPs and lung fluids, particularly within the alveolar macrophage region.

Oxidative potential of metal-polluted urban dust as a potential environmental stressor for chronic diseases.

Oxidative stress (OS) associated with metals in urban dust has become a public health concern. Chronic diseases linked to general inflammation are particularly affected by OS. This research analyzes the spatial distribution of metals associated with OS, the urban dust´s oxidative potential (OP), and the occurrence of diseases whose treatments are affected by OS. We collected 70 urban dust samples during pre- and post-monsoon seasons to achieve this. We analyzed particle size distribution and morphology by scanning electron microscopy, as well as metal(loid)s by portable X-ray fluorescence, and OP of dust in artificial lysosomal fluid by using an ascorbic acid depletion assay. Our results show that the mean concentration of Fe, Pb, As, Cr, Cu, and V in pre-monsoon was 83,984.6, 98.4, 23.5, 165.8, 301.3, and 141.9 mg kg-1, while during post-monsoon was 50,638.8, 73.9, 16.7, 124.3, 178.9, and 133.5 mg kg-1, respectively. Impoverished areas with the highest presence of cardiovascular, cancer, diabetes, and respiratory diseases coincide with contaminated areas where young adults live. We identified significant differences in the OP between seasons. OP increases during the pre-monsoon (from 7.8 to 237.5 nmol AA min-1) compared to the post-monsoon season (from 1.6 to 163.2 nmol AA min-1). OP values are much higher than measured standards corresponding to contaminated soil and urban particulate matter, which means that additional sources beside metals cause the elevated OP. The results show no risk from chronic exposure to metals; however, our results highlight the importance of studying dust as an environmental factor that may potentially increase oxidative stress.

Health risk assessment of gaseous elemental mercury (GEM) in Mexico City.

Emissions of gaseous elemental mercury (GEM or Hg0) from different sources in urban areas are important subjects for environmental investigations. In this study, atmospheric Hg measurements were conducted to investigate air pollution in the urban environment by carrying out several mobile surveys in Mexico City. This work presents atmospheric concentrations of GEM in terms of diurnal variation trends and comparisons with criteria for pollutant concentrations such as CO, SO2, NO2, PM2.5, and PM10. The concentration of GEM was measured during the pre-rainy period by using a high-resolution active air sampler, the Lumex RA 915 M mercury analyzer. In comparison with those for other cities worldwide, the GEM concentrations were similar or slightly elevated, and they ranged from 0.20 to 30.23 ng m-3. However, the GEM concentration was significantly lower than those in contaminated areas, such as fluorescent lamp factory locations and gold mining zones. The GEM concentrations recorded in Mexico City did not exceed the WHO atmospheric limit of 200 ng m-3. We performed statistical correlation analysis which suggests equivalent sources between Hg and other atmospheric pollutants, mainly NO2 and SO2, emitted from urban combustion and industrial plants. The atmospheric Hg emissions are basically controlled by sunlight radiation, as well as having a direct relationship with meteorological parameters. The area of the city studied herein is characterized by high traffic density, cement production, and municipal solid waste (MSW) treatment, which constantly release GEM into the atmosphere. In this study, we included the simulation with the HYSPLIT dispersion model from three potential areas of GEM release. Emissions from industrial corridors and volcanic plumes localized outside the urban area contribute to the pollution of Mexico City and mainly affect the northern area during specific periods and climate conditions. Using the USEPA model, we assessed the human health risk resulting from exposure to inhaled GEM among residents of Mexico City. The results of the health risk assessment indicated no significant noncarcinogenic risk (hazard quotient (HQ) < 1) or consequent adverse effects for children and adults living in the sampling area over the study period. GEM emissions inventory data is necessary to improve our knowledge about the Hg contribution and effect in urban megacity areas with the objective to develop public safe policy and implementing the Minamata Convention.

Release of Nanoparticles in the Environment and Catalytic Converters Ageing.

A Three-Way Catalyst (TWC) contains a cordierite ceramic monolith coated with a layer of Al2O3, CexZr1-xO2 and platinoids mixture. Under standard operation, the platinoid concentration decreases, exposing the remaining washcoat structure. After that particle release stage, the sintering process follows where the crystalline CexZr1-xO2 solution is broken and begins to separate into ZrO2 and CeO2 phases. ZrO2 is released to the environment as micro and nanoparticles, while a small amount of CeO2 generates a new AlxCe1-xO2 composite. The main effect of Ce capture is the growth in the size of the polycrystal structure from 86.13 ± 16.58 nm to 225.35 ± 69.51 nm. Moreover, a transformation of cordierite to mullite was identified by XRD analysis. Raman spectra showed that the oxygen vacancies (Vö) concentration decreased as CexZr1-xO2 phases separation occurred. The SEM-EDS revealed the incorporation of new spurious elements and microfractures favouring the detachment of the TWC support structure. The release of ultrafine particles is a consequence of catalytic devices overusing. The emission of refractory micro to nanocrystals to the atmosphere may represent an emerging public health issue underlining the importance of implementing strict worldwide regulations on regular TWCs replacement.

Gaseous Elemental Mercury (GEM) in the Mexico City Metropolitan Area.

This paper presents atmospheric gaseous elemental mercury (GEM) data recorded during two short-term monitoring surveys in the Mexico City Metropolitan Area (MCMA) at 12th May 2019 and at 22nd May 2020, during conditions of low and high human activity respectively. Results, although they are limited, can be considered as the representative range of exposure to GEM of the inhabitants of MCMA; differences in results reveal the impact of human activities on GEM background levels (2.53 and 3.76 ng m-3, respectively). GEM concentrations and their spatial distribution does not allow for the identification of important industrial sources and do not reach intervention pollution levels. The activity of the Popocatépetl volcano is not likely to have an effect on GEM in the MCMA. In spite the evident decrease in GEM concentrations compared with data previously reported, monitoring must be carried out routinely given Mexico's participation in the Minamata Convention on Mercury.

Identification of refractory zirconia from catalytic converters in dust: An emerging pollutant in urban environments.

Using catalytic converters is one of the most effective methods to control vehicle emissions. A washcoat of cerium oxide-zirconia (CeO2-ZrO2) has been used to enhance the performance of the catalytic converter device. To date, the prevalence of this material in the environment has not been assessed. In this study, we present evidence of the existence of inhalable zirconia in urban dust. Samples of the washcoat, exhaust pipe, topsoil, and road dust were analyzed by X-ray fluorescence, X-ray diffraction (XRD), scanning electron microscopy (SEM), Raman spectroscopy, photoluminescence (PL) spectroscopy, and thermally stimulated luminescence (TSL). The results showed a CeO2-ZrO2 phase separation after sintering. This causes the emission of ZrO2, CeO2, and CeZrOx particles smaller than 1 µm, which can likely reach the alveolar macrophages in the lungs. The Ce-Zr content in road dust exceeds geogenic levels, and a significant correlation of 0.87 (p < 0.05) reflects a common anthropic source. Chronic exposure to such refractory particles may result in the development of non-occupational respiratory diseases. The inhalable crystalline compounds emitted by vehicles are a significant environmental health hazard, revealing the need for further investigation and assessment of zirconia levels generated by automobiles in urban areas worldwide.

Robust Mesoporous CoMo/γ-Al2O3 Catalysts from Cyclodextrin-Based Supramolecular Assemblies for Hydrothermal Processing of Microalgae: Effect of the Preparation Method.

Hydrothermal liquefaction (HTL) is a promising technology for the production of biocrude oil from microalgae. Although this catalyst-free technology is efficient under high-temperature and high-pressure conditions, the biocrude yield and quality can be further improved by using heterogeneous catalysts. The design of robust catalysts that preserve their performance under hydrothermal conditions will be therefore very important in the development of biorefinery technologies. In this work, we describe two different synthetic routes (i.e., impregnation and cyclodextrin-assisted one-pot colloidal approach), for the preparation in aqueous phase of six high surface area CoMo/γ-Al2O3 catalysts. Catalytic tests performed on the HTL of Nannochloropsis gaditana microalga indicate that solids prepared by the one-pot colloidal approach show higher hydrothermal stability and enhanced biocrude yield with respect to the catalyst-free test. The positive effect of the substitution of the block copolymer Tetronic T90R4 for Pluronic F127 in the preparation procedure was evidenced by diffuse reflectance UV-visible spectroscopy, X-ray diffraction, N2-adsorption-desorption, and H2-temperature-programmed reduction measurements and confirmed by the higher quality of the obtained biocrude, which exhibited lower oxygen content and higher-energy recovery equal to 62.5% of the initial biomass.

Autohydrolysis pretreatment of Arundo donax: a comparison between microwave-assisted batch and fast heating rate flow-through reaction systems.

BACKGROUND: Autohydrolysis of lignocellulosic biomass in liquid hot water has been widely studied owing to its high efficiency and relatively low cost. In the perspective of industrial applications, continuous or semi-continuous processes are more interesting than batch systems. Moreover, microwave heating of pretreatment systems has been proposed to intensify the kinetics of the process. In this study, the autohydrolysis of Arundo donax was performed in pure liquid hot water using a microwave-heated batch reactor and a semi-continuous flow-through reaction system with fast heating rate at the same operating conditions with the aim of performing a systematic comparison between the two different experimental apparatuses. RESULTS: The effect of process temperature and time, biomass to water mass to volume ratio and water flow rate on the concentration and yield of hydrolysis products was investigated. The flow-through set-up allowed us to reach biomass solubilization up to 44.5 wt% on dry basis, while the batch system stopped at 34.5 wt% suggesting that the mass transfer could be the rate-determining step in the solubilization of the constituting biopolymers. For example, in the flow-through layout, using a flow rate of 3.5 mL/min at 200 °C with 20 min of processing time, quantitative recovery of hemicellulose was obtained with limited formation of degradation products. Interestingly, higher cellulose/hemicellulose extraction ratios were found using the microwave-assisted batch reactor. FTIR analyses of the solid residues recovered after the pretreatment offered independent information on the fractions of liquefied biopolymers complementary to those derived from HPLC and UV-Vis spectroscopy. CONCLUSIONS: Collected experimental results indicated that the flow-through system can be adopted to obtain complete solubilization of the hemicellulose fraction of Arundo donax addressing the product distribution in soluble compounds towards fermentable sugars with limited formation of sugar degradation products and with limited penalty in terms of dilution of the hydrolysate solution. It was also found that microwaves can promote cellulose depolymerization and solubilization, thus allowing a more comprehensive utilization of the biomass and that infrared spectroscopy can be a useful technique to estimate the effect of the pretreatment.